11-52 F INAL DRIVE
Rear Propeller S haft
Rear Propeller Shaft Removal
•
Remove:
Footboard (see Left and Right Footboard Removal in the
Frame chapter)
•
Slip the O-ring clamps [A] off the grooves on the rubber
boots [B].
•
Slide the rubber boot.
•
Push the front universal joint [C] rearward, and remove
the front end [D] from the engine.
•
Remove the rear propeller shaft [A] from the vehicle.
Rear Propeller S haft Installation
•
Wipe off any old grease:
Splines [A] of Propeller Shaft and Universal Joint
Output Shaft of Engine
Pinion Gear of Rear Final Gear Case
•
Inspect O-rings [B] and boots [C] for damage.
If any doubt exists, replace it with a new one.
•
Apply molybdenum disulfide grease to the spline [A] and
inside [B] of propeller shaft [C].
•
Install:
Boots [D]
Comments to this Manuals