DR ALL-TERRAIN Service Manual Page 242

  • Download
  • Add to my manuals
  • Print
  • Page
    / 594
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 241
6-14 CONVERTER SYSTEM
Drive P ulley
Drive Pulley Removal
Remove:
Torque Converter C over (see Torque Converter Cover
Removal)
Right Footboard (see Right Footboard Removal in the
Frame chapter)
Remove the three cover bolts [A] and install the drive pul-
ley holder [B].
Special Tool - Drive Pulley Holder: 57001-1520
Tighten the three cover bolts:
Torque - Drive Pulley Cover Bolts: 13 N·m (1.3 kgf·m, 113
in·lb)
Loosen the drive pulley bolt [C] (left-hand threads), hold-
ing the drive pulley with the drive pulley holder.
NOTE
The drive pulley bolt has left-hand threads. Turn the
wrench clockwise for l oosening.
Remove the drive pulley bolt, two washers, and the
stepped washer, but do not remove the drive pulley
holder yet.
Screw the drive pulley puller bolt [A] clockwise, while
holding the drive pulley with the drive pulley holder [B].
Special Tools - Drive Pulley Puller Bolt: 57001-1429
Drive Pulley Holder: 57001-1520
Remove the puller bolt and pulley holder.
Remove the drive pulley [A] from the crankshaft as s hown.
Drive Pulley Disassembly
Hold the drive & driven pulley holder (57001-1473) [A] and
the tapered guide of the holder (57001-1412) [B] in a vise
so that the upper surface on the holder is 7 mm (0.28 in.)
[C] above the vise.
Special Tools - Drive & Driven Pulley Holder: 57001-1473
Drive & Driven Pulley Holder: 57001-1412
Page view 241
1 2 ... 237 238 239 240 241 242 243 244 245 246 247 ... 593 594

Comments to this Manuals

No comments