DR ALL-TERRAIN Service Manual Page 551

  • Download
  • Add to my manuals
  • Print
  • Page
    / 594
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 550
ELECTRICAL SYSTEM 16-75
Actuator Control System
Check 4. Speed Sensor Inspection
NOTE
Be sure the battery is fully charged.
Support the vehicle on a s tand or a jack s o that the wheels
are off the ground.
Remove:
Seat (see Seat Removal in the Frame chapter)
Connect:
Controller Connector [A]
Hand Tester [B] (range: DC 25 V)
Test er ( +) Connector (P) Terminal [5]
Test er ( ) Connector (BK/Y) Terminal [10]
Install the needle adapters on the tester leads.
Special Tools - Hand Tester: 57001-1394
Needle Adapter Set: 57001-1457
Turn ON the ignition switch.
Spin a rear wheel, measure the voltage.
Speed Sensor O utput Voltage
Standard: repeat from 0 to 5 V
If the reading is not standard, replace the speed sensor.
When installing a new O-ring on the speed sensor, apply
grease all around the O-ring. Insert the speed sensor to
the fully seated position before tightening the mounting
bolt for the sensor.
NOTE
If the sensor is not fully seated before tightening the bolt,
the O-ring can be damaged and oil may leak.
Check 5. 2WD/4WD Shift Switch Inspection
NOTE
Be sure the battery is fully charged.
Remove:
Seat (see Seat Removal in the Frame chapter)
Connect:
Controller Connector [A]
Hand Tester [B] (range: DC 10 V)
Test er ( +) Connector (G) Terminal [7]
Test er ( ) Connector (BK/Y) Terminal [10]
Install the needle adapters on the tester leads.
Special Tools - Hand Tester: 57001-1394
Needle Adapter Set: 57001-1457
Turn ON the ignition switch.
Push the switch to the 4WD position.
Controller Output Voltage (at 2WD/4WD Shift Switch OFF,
4WD)
Standard:
about 5 V
If the reading is not standard, check the 2WD/4WD shift
switch or actuator controller unit.
Page view 550
1 2 ... 546 547 548 549 550 551 552 553 554 555 556 ... 593 594

Comments to this Manuals

No comments