16-60 ELECTRICAL SYSTEM
Meter
Multifunction Meter Unit Inspection
•
Remove:
Multifunction Meter Unit (see Multifunction Meter Unit
Removal)
CAUTION
Do not drop the meter unit.
[A] Meter Unit Lead Connector
[B] FI Indicator (LCD) Connector
[1] Speed Sensor Pulse
[2] Belt Indicator Light (LED) (–)
[3] Water Temperature Sensor (–)
[4] 2WD/4WD LCD Indicator (–)
[5] Fuel Gauge (Fuel Indicator LCD Segments)
[6] Meter Illumination (+)
[7] Reverse Indicator Light (LED) (–)
[8] Neutral Indicator Light (LED) (–)
[9] Ignition (+)
[10] Battery (+)
[11] Oil Pressure Warning Indicator Light (LED)
[12] Battery (–)
LED: Light Emitting Diode
LCD: Liquid Crystal Display
Check 1: LCD Segments Check
•
Using auxiliary wires, connect a 12 V battery to the meter
unit connector a s follows.
•
Connect the battery positive (+) terminal to terminal [10].
•
Connect the battery negative (–) terminal to terminal [12].
•
Connect terminal [9] to the battery (+) terminal.
○
When the terminal [9] is connected, all the LCD segments
appear for one second.
○
When the terminal [9] is disconnected, all the LCD seg-
ments d isappear.
If this display function does not work, replace the meter
unit.
Check 2: MODE and TIME SET Buttons Operation
Check
•
Connect the wires in the same manner as Check 1.
•
Check that when the MODE button [A] is pushed and
held continuously, the display [B] cycles through the four
modes.
ODO → TRIP A → TRIP B → Hour → ODO
If this display function does not work, replace the meter
unit.
Comments to this Manuals