3-88 FUEL SYSTEM (DFI)
Throttle Body Assy
•
Apply a thin coating of grease to the throttle cable lower
end.
•
Fit the throttle cable lower end [A] into the throttle pulley
[B].
•
Tighten the adjusting nut [C] and locknut [D].
•
Be sure to install the seal [A] on the throttle l ink case
cover.
•
Install the removed parts.
•
Check the throttle lever free play (see Throttle Lever Free
Play Inspection in the Periodic Maintenance chapter).
WARNING
Operation with an incorrectly routed cable could re-
sult in an unsafe riding condition.
•
Adjust:
Throttle Lever Free Play (see Throttle Lever Free Play
Inspection in the Periodic Maintenance chapter)
Idle Speed (see Idle Speed Adjustment in the Periodic
Maintenance chapter)
Throttle Bod y Assy Disassembly
CAUTION
Do not remove, disassemble or adjust the throttle
sensor [A] and throttle body assy, because they are
adjusted or set at the manufacturer. Adjustment of
these parts could result in poor performance, re-
quiring replacement of the throttle body assy.
CAUTION
Never drop the throttle body assy , especially on a
hard surface. Such a shock to the body assy can
damage it.
•
Remove:
Throttle Body Assy (see Throttle Body Assy Removal)
Screw [A]
Inlet Air Pressure Sensor [B]
Vacuum Hose [C]
•
Remove the drain tube [D], if necessary.
Comments to this Manuals