DR ALL-TERRAIN Service Manual Page 121

  • Download
  • Add to my manuals
  • Print
  • Page
    / 594
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 120
FUEL SYSTEM (DFI) 3-57
Speed Sensor (Service Code 24)
Speed Sensor Removal
Refer to the Speed Sensor Removal in the Electrical Sys-
tem chapter.
Speed Sensor Installation
Refer to the Speed Sensor Installation in the Electrical
System chapter.
Speed Sensor Inspection
Refer to the Speed Sensor Inspection in the Electrical
System chapter.
Input Voltage Inspection
Remove:
Right Footboard (see Right Footboard Removal in the
Flame c hapter)
NOTE
Be sure the battery is fully charged.
Turn the ignition switch OFF.
Disconnect the speed sensor connector.
Connect the measuring adapter [A] between the harness
connector [B] and speed sensor connector [C].
Special Tool - Speed Sensor Measuring Adapter: 57001
-1667
Connect a digital meter [D] to the measuring adapter lead
connectors.
Speed Sensor Input Voltage
Connections to Adapter
Meter (+) BK/Y (sensor BR) lead
Meter () BL/Y (sensor BK/Y) lead
Measure the input voltage with the engine stopped, and
with the connectors joined.
Turn the ignition switch ON.
Input Voltage at Sensor
Standard:
Battery Volta g e
If the reading is out of the range, check the wiring.
If the reading is good, check the output voltage.
Turn the ignition switch OFF.
Page view 120
1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 593 594

Comments to this Manuals

No comments