FINAL DRIVE 11-23
Output B evel Gears
Example 1: Decrease the thickness of the drive bevel gear
shim(s) by 0.1 mm (0.004 in.), and/or increase the thickness
of the driven bevel gear shim(s) by 0.1 mm (0.004 in.) to
correct the pattern shown below. Repeat in 0.1 mm (0.004
in.) steps if necessary.
Example 2: Increase the thickness of the drive bevel gear
shim(s) by 0.1 mm (0.004 in.), and/or decrease the thick-
ness of the driven bevel gear shim(s) by 0.1 mm (0.004
in.) to correct the pattern shown below. Repeat in 0.1 mm
(0.004 in.) steps if necessary.
Comments to this Manuals