DR ALL-TERRAIN Service Manual Page 237

  • Download
  • Add to my manuals
  • Print
  • Page
    / 594
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 236
CONVERTER SYSTEM 6-9
Torque Converter Cover
WARNING
Excessive imbalance or operating rpm could cause
torque converter pulley failure resulting in severe
injury or death. The pulleys of the belt drive torque
converter are precision balanced components de-
signed to operate within certain rpm limits. Disas-
sembly/assembly and servicing procedures of the
pulley assemblies must be followed closely. Modi-
fications to the engine or pulleys that increase rpm
may cause failure.
CAUTION
Do not turn the ignition switch OFF position from
ON position, while the torque converter cover is re-
moved.
If it is done, the learning control of Kawasaki Engine
Brake Control system works and the engine brake
actuator works an error operation.
NOTE
If the drive belt failure detection system is activated by
abnormal belt, the drive belt failure detection switch is
damaged. Make sure to replace the torque converter
cover (see Torque Converter Cover Removal/Installa-
tion).
Torque Converter Cover Remova l
Confirm that the ignition switch is in OFF position.
Remove:
Right Side Cover (see Right Side Cover Removal in the
Frame chapter)
Clamp Screws [A] and Clamps
Rubber Air Duct [B]
Remove:
Actuator Lead Connector and Drive Belt Failure Detec-
tion Switch Lead Connector [A]
Torque Converter Cover Bolts [B]
Torque Converter Cover [C]
Page view 236
1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 593 594

Comments to this Manuals

No comments