11-26 F INAL DRIVE
Front A xle
Front Axle Removal
•
Drain the front final gear case oil (see Front Final Gear
Case Oil Change in the Periodic Maintenance chapter).
•
Remove:
Front Wheel (see Wheel Removal in the Wheels/Tires
chapter)
Steering Knuckle (see Steering Knuckle Removal in the
Steering chapter)
•
Pull the front axle [A] in a straight line out of the front final
gear case.
Front Axle Installation
•
Wipe the old grease off the splines of the axle and the
gear case oil seal.
•
Visually inspect the splines of the axle.
If they are badly worn or chipped, replace the axle with a
new one.
•
Apply molybdenum disulfide grease to the axle splines.
•
Apply grease to the gear case oil seal.
•
Insert the left axle so that the teeth [A] fit in the grooves
[B].
•
Tap [A] the end of the front axle lightly and install the front
axle.
NOTE
○
The axle shaft must not come off easily.
Front Axle Joint Boot Inspection
•
Refer to the Front Axle Joint Boot Inspection in the Peri-
odic Maintenance chapter.
Front Axle Joint Boot Replacement
Outboard Joint Boot Removal
•
Remove:
Front Axle (see Front Axle Removal)
Boot Bands [A]
•
Scrap the removed boot bands.
•
Slide the joint boot toward the inboard joint.
Comments to this Manuals