DR Commercial Operations Instructions download pdf (Page 29)

Stopping the Engine

THE FLYWHEEL WILL STILL ROTATE FOR A WHILE AFTER THE ENGINE IS SHUT OFF. SHUT DOWN

THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP, REMOVE SPARK

PLUG WIRES, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES BEFORE

MOVING OR WORKING ON THE CHIPPER.

1. Slowly move the Throttle Control Lever all the way to the “IDLE” position and turn the Key Switch to

the “OFF” position.

2. Remove the Key for safety. The Key has a pressure lock that prevents it from vibrating loose during

operation. To remove the Key, push it in and then quickly and firmly pull it out. If the Key becomes

difficult to remove, spray FLUID FILM

or a similar non-conductive lubricant into the keyhole.

NEVER STOP THE ENGINE BY MOVING THE CHOKE LEVER TO THE CHOKE POSITION. THIS COULD

CAUSE AN ENGINE BACKFIRE RESULTING IN ENGINE DAMAGE.

NOTE: Close the fuel Shut-Off Valve when transporting or storing the DR RAPID-FEED CHIPPER.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 79 80

No comments

DR Commercial Operations Instructions Page 29