DR WIDE-CUT LAWN MOWER Operations Instructions download pdf (Page 40)

36 DR

WIDE-CUT LAWN MOWER

Removing and Replacing the Drive Chain

BEFORE PERFORMING ANY MAINTENANCE PROCEDURE

OR INSPECTION, STOP THE ENGINE AND WAIT FIVE (5)

MINUTES TO ALLOW ALL PARTS TO COOL.

DISCONNECT THE SPARK PLUG WIRE, KEEPING IT AWAY

FROM THE SPARK PLUG.

Tools Needed:

• 1/2" Wrench or Socket (Chain Cover)

• Flat-head screwdriver

• Needle Nose Pliers

1. Remove the Chain Cover (

Figure 28).

2. Remove the Tensioner Spring (Figure 29)

3. Remove the Master Chain Link (Figure 30). First,

remove the Lock Clip by spreading the Clip with the

Screwdriver and at the same time, slide the Lock Clip

back off the Master Link pins with the Needle Nose

Pliers. Next, remove the Side Plate, and then remove

the Master Chain Link.

4. Slowly feed the Chain out.

5. Install and route the new Chain (Figure 29).

6. Add the Master Chain Link (Figure 30) in the reverse

order of step 3.

7. Replace the Tensioner Spring (Figure 29).

8. Replace the Chain Cover and tighten the Lock Nuts.

Figure 28

Figure 29

Figure 30

Chain Cover

Tensioner

Spring

Chain Routing

Master Link

Side Plate

Lock Clip

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 63 64

No comments

DR WIDE-CUT LAWN MOWER Operations Instructions Page 40