DR SPRINT PRO-XL SELF-PROPELLED Operations Instructions download pdf (Page 26)

26 DR

TRIMMER/MOWER

 If you have the commercial or self-propelled model, also change the oil filter at this time. See the next page.

 Be certain to fill with oil before starting the engine. See page 10.

NOTE: The new Wheel will have a red Sleeve inside the Hub. This Sleeve keeps the Wheel Splines in place during shipment. As the

Wheel moves onto the Axle, the Sleeve will push out of the Wheel Hub. You can then remove and discard the Sleeve.

8. Install the Axle Nut and tighten it firmly. The installation is now complete.

NOTE: You have properly installed the Wheel when the Wheel locks against the Axle when you pull the Trimmer backward, and will

freewheel when pushed forward. The design of the Wheel Bearings is to be directional.

9. Repeat steps 2 through 8 for the opposite Wheel.

Engine Oil - All models

Tools and Supplies needed:

 SAE 30 HD Oil (refer to your Engine Owner’s Manual for quantity required)

 Suitable container for used oil

 Rags

 Wooden pallet or workbench

NOTE: Drain the oil when the Engine is warm. Warm oil drains quickly and

completely.

10. For convenience, place the machine up on a wooden pallet or workbench.

11. Remove the Oil Filler Cap and position a suitable oil receptacle beside the

Oil Fill Tube.

12. Make sure to securely tighten the Gas Fill Cap.

13. Using the handle of the DR TRIMMER/MOWER, tip the machine to the left

and drain the oil out through the Oil Filler Tube (Figure 46) into a suitable

receptacle.

14. Refill the Engine using SAE 30 HD oil to the level indicated on the Dipstick.

See page 10.

15. Reattach the Spark Plug wire.

NOTE: Be sure to use environmentally safe disposal procedures in the disposing of the used oil.

Adjusting the Wheel Clutch – PRO-XL SELF-PROPELLED Model

If the SELF-PROPELLED DR TRIMMER/MOWER will not drive forward when you squeeze the Wheel Clutch Lever or if the

machine moves forward without the operator squeezing the Wheel Clutch Lever (or the machine “walks”), you will have to adjust

the Wheel Clutch Cable.

Before performing any adjustment, maintenance procedure or inspection,

stop the engine, wait five (5) minutes to allow parts to cool and disconnect

the spark plug wire, keeping it away from the spark plug.

Before performing any maintenance procedure or inspection, stop the engine, wait five (5) minutes to allow all parts to cool.

Disconnect the spark plug wire, keeping it away from the spark plug.

Tightened Fuel

Fill Cap

Figure 46

Oil Fill Tube

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 51 52

No comments

DR SPRINT PRO-XL SELF-PROPELLED Operations Instructions Page 26