DR ALL-TERRAIN Operations Instructions download pdf (Page 19)

ALL-TERRAIN

™

FIELD and BRUSH MOWER Safety & Operating Instructions 13

To Remove/Replace the Blade

Tools Needed:

· 15/16" wrench or socket

· air wrench if available

· rag or gloves to handle the blade

· 2 x 4 to brace blade

WARNING: Always disconnect the

spark plug wire before servicing your

machine.

1. Block the blade with a piece of wood

between the blade and the skid on the

chute side of the deck (Figure 15).

2. Remove the blade lock nut (right-hand,

regular thread) and washer.

Caution: Be careful not to get injured

when pushing or pulling the wrench next to the blade.

3. Remove the blade.

4. Mount the new blade, washer and lock nut.

Note: Be sure the blade is seated completely over the small ridge in the spindle hub before

tightening the lock nut.

To Adjust the Wheel Clutch

When properly adjusted, tension on the wheel clutch

lever should increase when the lever is about parallel

to (almost touching) the handlebar grip.

Tools Needed:

· (2) 1/2" wrenches

WARNING: Always disconnect the spark plug

wire before servicing your machine.

1. Find the wheel clutch adjustment on the clutch

bracket on the underside of the machine (Figure

16).

2. Loosen the nut on the front (threaded) side of the

bracket by 1/8" to 1/4", then tighten the nut on the

back against the bracket. Check the tension on the

clutch lever and repeat the adjustment as needed.

Figure 15

Figure 16

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

No comments

DR ALL-TERRAIN Operations Instructions Page 19