DR POWERWAGON-PRO Operations Instructions download pdf (Page 19)

POWERWAGON

™

Safety & Operating Instructions

Note: Turn the nut only 1/4 turn at a time, and then test the brake to see if the adjustment

worked. If needed, adjust the nut another 1/4 turn and test again.

Brake Cable Adjustment

The brake cable is factory set (Figure 19).

If you think the brake cable needs to be

adjusted, you may actually need to replace

the brake pads. See below.

To Change the Brake Pads

If your DR

POWERWAGON

™

rolls on

slopes when the brake is set, and you have

tried adjusting the brake, the brake pads

may need to be replaced.

Tools and Supplies Needed:

• 1/2" wrench or socket

• Mat or container for loose parts

WARNING: Always disconnect the

spark plug wire before servicing your

machine.

Note: You may want to remove the wheel

to provide easier access to the brake area

(see page 14).

1. Find a level area to work. The parking

brake should NOT be engaged. Chock

the wheels so the machine cannot move.

2. Locate the brake caliper at the right

front of the machine (Figure 20).

Remove the two caliper bolts holding

the brake caliper with a 1/2" wrench,

then carefully remove the caliper.

Figure 19

Figure 20

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 28 29

No comments

DR POWERWAGON-PRO Operations Instructions Page 19